Edited to add: The original graphic theme for this blog wasn’t working out, so we’re trying “Arclite”. Please let us know if there’s any issues with the UI. Thanks!
Yesterday after getting the permits all straightened out I got to spend about three hours working in the bathroom. Today it was about the same — got there about 3:00 and left at 6:00.
The permits and plans “prominently posted at the job site”:
The bathroom before yesterday and today’s demo. I’d already removed the chair rail molding, the sink and the toilet:
I pulled off all the remaining moldings and door casings (carefully for the main door, since I’m putting them back). I got all the drywall off of one and a half walls, and all the towel hooks, mirror, etc., which are in pretty good shape and will be appearing in a Craigslist ad very soon.
Bathroom at end of day today:
So I now think that, in the 1930 floor plan, what is now the parlor was the main bedroom. Either in the original plan or very soon thereafter, they framed in a closet against the wall opposite the bathroom with 2x2s, which is why the bathroom side of that wall is narrow horizontal T&G instead of the wide vertical T&G on the room side that’s used everywhere else.
Much later, very possibly in 1994, the owner knocked out the part of the bathroom/closet wall and drywalled the bathroom.
You can see the framing of the wall between the old closet and the old bathroom in these two photos:
You can see the end stud and the top plate of the 2×4 wall that was removed, along with nail and pipe/wire holes.
I say in 1994 because I found a bible hidden in the walls with a note inside reading “Hid 12-17-1994”.
The T&G cladding in the old bathroom was removed (assuming it was ever there), so in there the drywall was 1/2″ and fastened to the studs. In the old closet, the T&G was not removed so they put 1/4″ drywall directly over it. This still didn’t make the walls even, so they had to add wider moldings to the bathroom side.
It wasn’t a load-bearing wall, so I don’t understand why they cut the bottom plate and removed the intermediate studs, but didn’t cut the top plate or remove the end stud. It would have been so much easier to make it look good.
WTF #1: Notice how the cold stubout comes up from the floor but the hot stubout comes down from somewhere:
Here’s the plan for the next couple of days:
- go up in the attic and scoop away all the rockwool insulation from above the bathroom ceiling so I can demo without having all that fall down on me
- find the shutoff valve for the tub/shower and then remove the faucets and handles
- remove the window casing, the rest of the drywall, the T&G cladding, the vinyl floor, and the plastic shower surround
- turn off the power and trace and cap the wiring (removing the hidden junctions or unboxed splices that I’m sure are up in the attic)
- drop at least part of the downstairs bathroom ceiling and disconnect the bathub drain
- trace the water lines back as far as I can to the earliest common point where I can cap them
- hope like hell the subfloor is okay and doesn’t need replacing
The building inspector is scheduled to come by sometime on Monday to review and approve the plans, and I want the bathroom completely opened up by then so he can see the stub wall I want to move isn’t load-bearing. Hopefully he won’t make me reframe the 2×2 old closet wall.